Step 4: Try to boot your device in recovery mode You may release it when you can see ‘Safe mode’ in the bottom left corner of the screen.Continue holding the Volume Down button until the device finishes rebooting.As soon as you can see the ‘Samsung Galaxy S7’ on the screen, release the Power key and immediately hold the Volume Down key.So, if one of your apps caused the problem, then it should successfully boot in safe mode. If it doesn’t respond, leave it plugged in for ten minutes and then try the forced reboot procedure again followed by an attempt to turn it on normally.īooting in safe mode will temporarily disable all third-party apps. Aside from the very obvious reason, you will also know how the phone responds when it senses electricity is flowing through its circuits.
So, after you tried to force your phone to reboot and it didn’t respond, try to plug in the charger and see if the phone charges. It could be because its battery was completely drained.
#S7 BATTERY GURU UPDATE#
In your description, you mentioned that your device just turned off after the update and won’t respond when the Power key is hit. Step 2: Charge your phone as the battery might have just been drained The phone will reboot successfully provided that it was just a system crash and that there’s enough battery left.Press and hold the Volume Down and Power keys together for 10 seconds.So, for this kind of issues, first thing I would do is do the forced reboot procedure: The thing is, your device can’t get out of it without your intervention. System crashes are among the most common reasons why a phone won’t turn on or respond to anything. Step 1: Forced Reboot your Galaxy S7 to make sure it’s not a system crash issue But I ask you to troubleshoot it and here’s what you need to do: In this case though, there are only two possibilities if it’s not the firmware that has the problem, then it must be the hardware.
However, being a technician myself, I’ve seen issues that appeared to have very obvious causes but were actually caused by other factors. It is tempting to just immediately jump into a conclusion that the new firmware caused this problem. Apparently, the problem started after the phone updated its firmware. So, I’m stuck with a phone that won’t turn on and I can’t do anything with it. It updated its OS, turned off on its own and when I pressed the Power key to turn it on, it didn’t. I have a problem with my new Samsung Galaxy S7. Troubleshoot Samsung Galaxy S7 that won’t turn on
Just fill up our questionnaire and we’ll do all research for you. If you need further assistance, you can always contact and provide us will all necessary information about the problem. Find ones that are similar or related to yours and use the solutions we suggested. If you have other issues with your phone, visit our Galaxy S7 troubleshooting page for we have already addressed a lot of issues with this device.
#S7 BATTERY GURU HOW TO#
Continue reading below so that you’d know how to deal with these issues as they might happen to your sooner or later. These issues might be caused by firmware and hardware problems but you have to rule out the first possibility. In this post, I will address three of the most common issues such as S7 won’t turn on, can’t boot up successfully and won’t respond. We’ve been receiving a lot of messages from Samsung Galaxy S7 owners that have experienced power-related issues with their phones. What you need to do if your Galaxy S7 became unresponsive after an update.Understand and troubleshoot the problem that prevents your phone from booting up normally.Learn how to troubleshoot your Samsung Galaxy S7 (#GalaxyS7) that won’t turn on when you press the Power key.
0 kommentar(er)
